04-14-2022, 10:49 AM
(04-14-2022, 09:05 AM)Sled21 Wrote: Right, when you use a home printed lower (which normally would come from the manufacturer with a serial number), you still have to buy the upper, which is the barrel, bolt, firing pin, etc. These still leave the same tool marks on the round going down the barrel and on the ejected casing. If home printed lowers are such a problem, then the quick fix is make the manufacturer stamp the upper with the serial number instead of the lower.
Which I would have zero issue with, as long as they don't classify the upper as a firearm as well as the lower.
