Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dalton Speaks after being cut
#25
(05-02-2020, 03:45 PM)McC Wrote: Is it a fact that no trade happened?  Yes.  End of story.


Not end of story.

There might have been a trade if the draft had gone differently.

You can claim you know as much as you like, but that does not make it true.

I was one of the MANY people around here who said it was highly unlikely that any team woudl trade for dalton because of his salary, but you are the only one obsessed with making yourself look better because of it.

Get over yourself.
Reply/Quote





Messages In This Thread
Dalton Speaks after being cut - Luvnit2 - 05-02-2020, 10:07 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:07 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:18 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:26 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:25 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 03:45 PM
RE: Dalton Speaks after being cut - fredtoast - 05-02-2020, 04:06 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 04:47 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:02 PM
RE: Dalton Speaks after being cut - McC - 05-03-2020, 11:49 AM
RE: Dalton Speaks after being cut - McC - 05-03-2020, 12:28 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 03:51 PM
RE: Dalton Speaks after being cut - Synric - 05-02-2020, 03:54 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 03:55 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 03:48 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 10:01 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 10:34 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 10:43 PM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 11:30 PM
RE: Dalton Speaks after being cut - jason - 05-03-2020, 10:55 AM
RE: Dalton Speaks after being cut - McC - 05-02-2020, 03:49 PM
RE: Dalton Speaks after being cut - Cicero - 05-02-2020, 08:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)