Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question on circular saws
#8
(04-05-2017, 05:25 PM)bfine32 Wrote: Pretty sure most circular saws are reversed thread. Make sure you are turning the right way.

^^This

It's not lefty loosey, righty tighty...
[Image: 4CV0TeR.png]
Reply/Quote





Messages In This Thread
Question on circular saws - fredtoast - 04-05-2017, 03:48 PM
RE: Question on circular saws - Sabretooth - 04-05-2017, 05:19 PM
RE: Question on circular saws - bfine32 - 04-05-2017, 05:25 PM
RE: Question on circular saws - jfkbengals - 04-05-2017, 09:35 PM
RE: Question on circular saws - fredtoast - 04-06-2017, 12:38 PM
RE: Question on circular saws - jfkbengals - 04-06-2017, 09:03 PM
RE: Question on circular saws - fredtoast - 04-07-2017, 09:28 AM
RE: Question on circular saws - Benton - 04-06-2017, 12:54 AM
RE: Question on circular saws - HarleyDog - 04-06-2017, 07:48 AM
RE: Question on circular saws - jfkbengals - 04-08-2017, 10:49 AM
RE: Question on circular saws - XenoMorph - 04-14-2017, 12:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)