Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is it...or is it...
#9
(12-15-2016, 03:07 PM)Sabretooth Wrote: I used to train operators to run machine tools and test equipment.
Some folk learn better by audio instruction,others are visual learners, and some need hands on formats.
A percentage of students " just don't get it " despite good quality instructors. Sad

Some expecting a foot and half and get six feet and an inch. 

And, some promising a foot and a half and barely deliver more than an inch. 

A lot of it depends on if a guy measures or a girl, which is why I asked if it was in a personal ad!  Wink
JOHN ROBERTS: From time to time in the years to come, I hope you will be treated unfairly so that you will come to know the value of justice... I wish you bad luck, again, from time to time so that you will be conscious of the role of chance in life and understand that your success is not completely deserved and that the failure of others is not completely deserved either.
Reply/Quote





Messages In This Thread
Is it...or is it... - Nebuchadnezzar - 12-12-2016, 10:49 PM
RE: Is it...or is it... - Bengalzona - 12-12-2016, 11:37 PM
RE: Is it...or is it... - Nebuchadnezzar - 12-13-2016, 12:14 AM
RE: Is it...or is it... - Beaker - 12-13-2016, 09:37 PM
RE: Is it...or is it... - Sabretooth - 12-15-2016, 03:07 PM
RE: Is it...or is it... - xxlt - 12-15-2016, 10:06 PM
RE: Is it...or is it... - GMDino - 12-26-2016, 01:09 PM
RE: Is it...or is it... - fredtoast - 12-15-2016, 12:25 PM
RE: Is it...or is it... - xxlt - 12-15-2016, 10:07 PM
RE: Is it...or is it... - fredtoast - 12-22-2016, 02:08 PM
RE: Is it...or is it... - xxlt - 12-23-2016, 10:38 AM
RE: Is it...or is it... - xxlt - 12-15-2016, 12:46 PM
RE: Is it...or is it... - Nebuchadnezzar - 12-15-2016, 02:05 PM

Forum Jump:


Users browsing this thread: 8 Guest(s)