Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Donut Club
#1
http://mmqb.si.com/mmqb/2015/10/20/nfl-minnesota-vikings-donut-club
Reply/Quote
#2
(10-26-2015, 01:00 PM)WhoDeyWho Wrote: http://mmqb.si.com/mmqb/2015/10/20/nfl-minnesota-vikings-donut-club

^ This message is approved by Homer J Simpson.

  • [Image: ustv_homer_simpson_1.jpg]
  • [Image: th?id=OIP.M0d30b41543d97867ca502a8ac3b5a...=300&h=300]
  • [Image: th?id=OIP.M8a885e92023594b95d7f5f33e8f9f...=300&h=300]
JOHN ROBERTS: From time to time in the years to come, I hope you will be treated unfairly so that you will come to know the value of justice... I wish you bad luck, again, from time to time so that you will be conscious of the role of chance in life and understand that your success is not completely deserved and that the failure of others is not completely deserved either.
Reply/Quote
#3
Very cool.
[Image: 4CV0TeR.png]
Reply/Quote
#4
Useless fact.

When I was in college I made the donuts for the Dunkin Donuts on Brainard Road in Chattanooga.

Our kitchen was not automated, so I had to put the warm donuts on long rods then dip them in warm glaze. The rods then hung over the glaze trough until the excess had ripped off and they had cooled and dried, there were always some of the warm donuts that would break apart and fall off the rods into the glaze. The best part of the job was eating those warm, glaze-soaked donut chunks.
Reply/Quote
#5
(10-26-2015, 02:56 PM)fredtoast Wrote: Useless fact.

When I was in college I made the donuts for the Dunkin Donuts on Brainard Road in Chattanooga.

Our kitchen was not automated, so I had to put the warm donuts on long rods then dip them in warm glaze.  The rods then hung over the glaze trough until the excess had ripped off and they had cooled and dried, there were always some of the warm donuts that would break apart and fall off the rods into the glaze.  The best part of the job was eating those warm, glaze-soaked donut chunks.

The freshman 15 would have been more like the freshman 30.  
Reply/Quote





Forum Jump:


Users browsing this thread: 4 Guest(s)